1 - Wire mesh demisters
2 - Knitted wire mesh
3 - ST Inlet devices
4 - Calming baffles
5 - Parallel plate packs
6 - Rectifier
7 - Straightner
___-Standard VP
___-High performance VP
___-W bank
9 - Liquid distributors
10 - Support grids
11 - Air treatment
12 - Candles, dryers for cyclone, feed diffuser, electro welded grids


1 - 2Ph Separation
2 - 3Ph Separation
3 - Sizing and simulation
1 - General brochure
2 - Wire mesh separators
3 - Vane pack separators
4 - ST inlet device
5 - Liquid-liquid separation
6 - 2 ph & 3 ph separation
7 - Knitted wire mesh



AFP Tech can provide some other kind of internals like wire mesh candles, dryers or inlet distributors. These internals are generally made on the base of customer's design and drawings.

CANDLES: sometimens happens that it's necessary to treat a big gas flowrate but, at the same time, the diameter of the vessel is not enough to guarantee that the gas velocity is between the max and the min allowed velocity limits.
In this case the use of a candle can be the right solution providing the right suface for the gas flow, working with the right velocity and reducing the vessel diameter.
ELECTRO WELDED GRIDS: this kind of grids are often used to contain the mesh in the wire mesh separators or in the agglomerator apllied to vane packs. Are also used as contaiment in many kind of package.
When needed we can supply electro welded grates with different pitches and wire diameter. They are available in stainless steel and carbon steel.
DRYER FOR CYCLONES: this kind of vane pack are often used in “steam drums” located over cyclones to eliminate small liquid droplets drained by vapour stream. Compared with wire mesh separators the thickness of these packs is lower so they are useful when the available space is small. They can be made with different shapes and profiles to obtain the best performances in terms of droplets separation and pressure drop.
FEED DIFFUSER: in some processes it's required a correct distribution of the flow inside a vessel and, often before some other process internals like wedge screens. In this cases it's possible to use a feed diffuser. There are many different kinds of diffuser and, on the base of customer's need, international standard and customer's design, we can draw and make some of them.

- AFP Tech Srl -
Registered office: Via Campagnola 30/A, 23854 - Olginate (LC) – Italy
VAT number: 03292570136 / Tax Code: IT 03292570136 / R.E.A.: n° 312452
Capital: Euro 50.000,00 i.v.

Phone: +39-0341-604625 - Sales office: sales@afptech.eu - Mobile: +39-339-6855147