_CONTACTS AND LOCATION
-------------------------
___
WIRE MESH PRODUCTS
1 - Wire mesh demisters
2 - Knitted wire mesh
-------------------------
___TOWER INTERNALS
3 - ST Inlet devices
4 - Calming baffles
5 - Parallel plate packs
6 - Rectifier
7 - Straightner
8 - VANE PACKS
___-Standard VP
___-High performance VP
___-W bank
9 - Liquid distributors
10 - Support grids
-------------------------
___OTHER
11 - Air treatment
12 - Candles, dryers for cyclone, feed diffuser, electro welded grids

********************

___PHOTO GALLERY
-------------------------
___ENGINEERING
1 - 2Ph Separation
2 - 3Ph Separation
3 - Sizing and simulation
-------------------------
___BROCHURES
1 - General brochure
2 - Wire mesh separators
3 - Vane pack separators
4 - ST inlet device
5 - Liquid-liquid separation
6 - 2 ph & 3 ph separation
7 - Knitted wire mesh
-------------------------
___GENERAL TERMS OF SALE



 



- STANDARD VANE PACKS -



Vane pack assembled before packging
__________________________________________________________

Vane packs, with wire mesh separators, are the most widely used internals when the need is to separate liquid droplets carried by gaseous streams.

SEPARATION: vane packs are composed by sets of vane profiles where the gas passes through and, changing direction, it clashes on the vanes and are captured by the hooks. Liquid droplets slide down along the vanes and are drained down by a tube into the liquid section of the vessel.
CROSSING SPEED: Usually, compared with wire mesh separators, the crossing speed is higher and that allows to reduce the crossing area and the vessel diameter.
PERFORMANCES: on the other side, the diameter of the smallest separated liquid droplet is bigger then in a wire mesh separator. For this reason vane packs are not indicated when high performance of separation are requered.

Left: vane pack customized for separation in small vessels
Center: explanation of droplets interception in different kinds of vane pack
Right: a vane pack for vertical vessels
__________________________________________________________

Samples of vane packs optimized for a low pressure drop and separation in vertical flows

———————————————————————————
- AFP Tech Srl -
Registered office: Via Campagnola 30/A, 23854 - Olginate (LC) – Italy
VAT number: 03292570136 / Tax Code: IT 03292570136 / R.E.A.: n° 312452
Capital: Euro 50.000,00 i.v.

Phone: +39-0341-604625 - Sales office: sales@afptech.eu - Mobile: +39-339-6855147